You're here: 

AMS Apparatebau

Plasma Cutting Robot drastically reduces production time

In the Saxon AMS Apparate-Maschinen-Systeme Technology GmbH production the time-consuming manual work of cutting the stainless steel material is done by a robot. Instead of the previous two days manual work, the robot only needs less than four hours. The robot is equipped with a tactile sensor for an exact workpiece measurement. Thus manual marking-out works are not required. And only a minimum of rework is necessary. The two-station system ensures highest system efficiency because the operator works parallel to the robot. Due to the RoboPlan software the workpieces can be programmed offline on a PC during cutting. This considerably reduces the set-up and downtimes. In addition, there is a high level of conformity from the drawing to the product. In this way AMS can produce reproducible components which will make the subsequent exchange of containers simply possible.

Container base
Plasma Cut
Plate 4 - 8 mm

You intend to buy a system for automated welding?

Your contact partner

Manuel Benner
Phone: +49 (0)2773/85-0

Write an e-mail